25
Chapter 3: Phantom Software
Specifies the camera’s operation mode in relation to
CineMag recording: Loop (record to RAM first) or R/S
(bypass RAM and record directly to CineMag).
It also displays the amount of ‘Free’ space and size
(in Gigabytes) of the Phantom CineMag.
In ‘Loop’ mode to begin recording to the camera’s RAM
click the red ‘Capture’ button.
Flash Memory
Recording a Cine
The red ‘Capture’ button changes to ‘Abort Recording’
and the green ‘Trigger’ button is enabled when the
camera is recording. The Abort Recording button instructs
the camera to stop recording, leaving the camera’s
RAM empty.
Selecting the ‘Trigger’ button instructs the camera to
immediately stop recording when the ‘Trigger Position’ is
set to zero. If a value greater than zero is set, the camera
will continue to record ‘post-trigger’ frames until the
userspecified value is met.
Triggering the Camera
Set R/S (Run/Stop) mode by selecting the ‘Direct
Recording to CineMag’ box in the Flash Memory section.
Start recording by clicking the red ‘Record’ button. Once
the camera is recording directly to the Phantom CineMag
the ‘Record’ button changes to a ‘Stop Recording’ button.
If a clip exists in the camera’s memory, you will
be asked if you are sure you wish to delete it
before continuing. If yes, click ‘Delete cine(s)
and start new recording’.
Using the camera’s ‘Trigger’ button, or an
external trigger signal provides a more accurate
trigger to the camera.
Summary of Contents for v1212
