Phase Technology TEATRO TSB3.0, Owners Manual/Install Manual

6

[FIGURE 4]

on the Mounting Bracket with the center of mounting holes on 
the rear of the speaker and fasten using the supplied Table Top 
Mounting Screws for each bracket.  

Note:

 When mounting the table top brackets, fasten the brackets 

to the far end mounting holes on each side of the speaker cabinet.

STEP 3

There are three Euroblock connector terminals on the rear of the 
speaker cabinet. The terminals are marked for Right Input, Center 
Input and Left Input and should be connected to the respective 
speaker channel outputs on your receiver. Connect the speaker 
wires to the correct terminals observing the polarity indicated on 
the Euroblock connector. Strip about .25” of insulation from the 
wires and separate the wires as necessary. Connect the signal 
wires to the 2-pin Euroblock connectors ((+) indicates positive and 
(-) indicates negative) 

(Figure 5)

. Make sure the connections are 

tight. Tuck the speaker wires behind the Soundbar cabinet, using 
tie wraps if necessary to secure wires.

OFF

ON

EVT

[FIGURE 6]

With emblem removed

[FIGURE 5]

STEP 4

Since the TSB3.0 speaker performs as the front three speakers 
in a home theater system they are to be used and set up as you 
would any normal 5.1 to 7.2 surround sound system for balance 
and level adjustments. For the best performance, the amplifier 
should be set to the small speaker mode for the left/center/right 
front speakers. The subwoofer setting should be set between 
80 - 100 Hz. We recommend the use of our Phase Technology

®

subwoofers and surround speakers to complement your TSB3.0.

STEP 5

The EVT

™

 switch 

(Figure 6)

, located on the front of the speaker 

under the Phase Technology emblem on the grille, activates Phase 
Technology’s Enhanced Voice Technology feature. This feature is 
designed to improve the clarity of the voice or dialogue from the 
center channel speaker in the system. Flipping the switch to the 
on position (right) engages the circuit and off position (left) turns 
it off. The emblem can easily be removed and 

replaced. Use the 

tip of a pencil or a small screw driver to engage or turn off the EVT 
function.