background image

Troubleshooting  

Phason 

8  

2009-09-10 

 

 

Limited warranty 

This warranty applies only to the Phason Inc. (Phason) Modulating Temperature Control (MTC-
4C). If you need warranty service, return the product and original proof of purchase to your 
dealer. 
Phason warrants the MTC-4C subject to the following terms and conditions. 
This warranty is valid only to the original purchaser of the product, for two years from the 
manufacturing date. The manufacturing date is stated in the first eight digits of the serial number 
in the form year-month-day.  
Phason hereby warrants that should this product fail because of improper workmanship, Phason 
will repair the unit, effecting all necessary parts replacements without charge for either parts or 
labor. 

Conditions 

‹

 

Installation must be done according to Phason’s enclosed installation instructions. 

‹

 

The product must not have been previously altered, modified, or repaired by anyone other 
than Phason. 

‹

 

The product must not have been involved in an accident, misused, abused, or operated or 
installed contrary to the instructions in our user and/or installation manuals. Phason's opinion 
about these items is final. 

‹

 

The person requesting warranty service must be the original purchaser of the unit, and 
provide proof of purchase upon request. 

‹

 

All transportation charges for products submitted for warranty must be paid by the purchaser.

Except to the extent prohibited by applicable law, no other warranties, whether expressed or 
implied, including warranties of merchantability and fitness for a particular purpose, shall apply to 
this product. Any implied warranties are excluded.  
Phason is not liable for consequential damages caused by this product.  
Phason does not assume or authorize any representatives, or other people, to assume any 
obligations or liabilities, other than those specifically stated in this warranty. 
Phason reserves the right to improve or alter the MTC-4C without notice. 

 

Phason controls are designed and manufactured to provide reliable performance, but they 
are not guaranteed to be 100 percent free of defects. Even reliable products can experience 

occasional failures and the user should recognize this possibility.  
If Phason products are used in a life-support ventilation system where failure could result in 
loss or injury, the user should provide adequate back up ventilation, supplementary natural 
ventilation, or an independent failure-alarm system. The user's lack of such precautions 

acknowledges their willingness to accept the risk of such loss or injury. 

 

 
 

Phone: 204-233-1400
Fax: 204-233-3252 

Phason Inc. 

2 Terracon Place 
Winnipeg, Manitoba, Canada 
R2J 4G7 

E-mail:

support@phason.ca

Web site:  www.phason.ca 

Summary of Contents for MTC-4C









Reviews: