background image

 

 

 

 

OFF (APG.)

MAX

 (MÁX.)

1 AAA

1.5V

IGNITOR

( Encendedor )

ON/MIN

(ENC./MÍN.)

LIGHTING INSTRUCTIONS 

1.  Push in gas control knob slightly and 

2.  Turn gas control knob to “ON/MIN”.

 

3.  Push in gas control knob all the way 

 

4.  If the burner does not light in 15 

 

1.   Push in gas control knob slightly and turn to “OFF”.

 

TO TURN OFF GAS 

INSTRUCCIONES DE ENCENDIDO

PARA CERRAR EL GAS

1.  Presione ligeramente la perilla de control del gas y gírela a la

2.  Gire la perilla de control del gas a “ENC/MÍN” (encendido/mínimo).

3.  Presione la perilla de control del gas hasta el fondo y mantenga presionada.

 

4.  Si el quemador no se enciende en 15 segundos, suelte la perilla y esta

encender el quemador nuevamente, repita los pasos 1 al 3.

 

 

1.  Presione ligeramente la perilla de control del gas y gírela a la

turn to “OFF”. 

and hold. Continue to press the

ignition button for 15 seconds.

seconds, release the knob and it will 

pop back out. Wait 5 minutes before attempting

to light the burner again, repeat step 1 to 3. 

 posición “APG” (apagado).

Siga presionando el botón de encendido durante 15 segundos.

volverá a su posición hacia afuera. Espere 5 minutos antes de intentar

posición “APG” (apagado)

Figure 6

cylinder / regulator connection (Figure 7)

gas valve / bellows connection (Figure 8)

 

 

 

Battery

Leak test

WARNING:

1. Please observe proper polarity and use the correct battery type when installing or replacing the 
battery. Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of time.

1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak, disconnect the propane supply 
and call a gas appliance service shop or your local propane gas supplier. 

To prevent fire or explosion hazard when testing for a leak:

Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the control panel 
to access the battery compartment. The ignitor module requires one AAA size battery. BATTERY IS NOT INCLUDED.

OPERATION INSTRUCTIONS

7

LIFE GETS BETTER WITH PHI VILLA

Summary of Contents for E02GS019











Reviews: