3
Remove Battery
1. Make sure the phone is off.
2. Remove the back cover.
3. Remove the battery from the small opening on top side of the
battery compartment.
Install MicroSD Card
1. Make sure your device is turned off.
2. Remove the back cover and battery.
3. With the MicroSD card’s gold contacts facing down insert the card
into the card slot.
IV. CHARGING THE BATTERY
The battery is partially charged when shipped. Before you turn on and
start using your phone, it is recommended that you fully charge the
battery. Some batteries perform best after several full charge/
discharge cycles.
1. Connect the power adapter and the USB connector of your phone
with the USB cable
2. Plug in the power adapter to an electrical outlet to start charging the
battery.
NOTICE:
When charging the battery with the phone on, the charging
battery icon is displayed in phone’s status bar. After the battery is fully
charged, the charging battery icon turns a full battery icon.
