150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
22
Chapter 4: Software Configuration
Static/Dynamic IP Address: For PPPoA/PPPoE connection, you need to specify the public IP
address for this ADSL Router. The IP address can be either dynamically (via DHCP) or given IP
address provided by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and
Gateway address.
Dynamic Route:
Select this option to specify the RIP (Routing Information protocol) version for
WAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are both sent in RIP2
format, the difference is that RIP2-M using Multicast, while RIP2-B using Broadcast format.
Direction: Select this option to specify the RIP direction. None is for disabling the RIP function.
Both means the ADSL Router will periodically send and accept routing information, and then
incorporate them into routing table. IN only means the ADLS router will only accept but will not
send RIP packet. OUT only means the ADSL router will only send but will not accept RIP packet.
4. Bridge Mode
If you select this type of connection, the modem can be configured to act as a bridging device
between your LAN and your ISP. Bridges are devices that enable two or more networks to
communicate as if they are two segments of the same physical LAN.
Note: After you finish the internet configuration, please click APPLY/SAVE to make the settings
take effect.
