19
1072_0_Product_Manual - February 24, 2011 2:52 PM
Manage saved networks
Join This Network
- Joining a specific network will temporarily disable all other saved networks, so that the specific
network will be joined, if available. The other networks will remain disabled until the board is reset, or another
network is added.
Delete This Network
- Delete a saved network. There is no confirmation and this cannot be undone.
Enable / Disable
- Selected networks that are enabled will be joined automatically. Disabled networks will never be
joined.
Wireless Network Settings
TCP/IP settings
- DHCP will set the system IP Address, Subnet Mask, and Gateway automatically. In the absence of
a DHCP server, Static should be used and filled in manually.Note that the same TCP/IP settings will be used at all
access points.
DNS settings
- Switch the DNS settings between Automatic and Manual. DNS can be set up automatically if DHCP is
enabled. Otherwise, up to two DNS servers can be specified. Note that DNS settings are system-wide and will apply
to all interfaces.
Phidgets: Status
Library Version
The version of the installed Phidget21 library. These libraries are included and are updated along with the firmware.
List of attached Phidgets
A list of all detected Phidgets connected to the PhidgetSBC. This includes the integrated PhidgetInterfaceKit and
displays both the serial number and version.
Phidgets: Webservice
The Phidget webservice is a simple server that allows Phidgets connected to the PhidgetSBC board to be opened
over the network. This is enabled by default and starts with the SBC. The webservice also exposes a key-value
dictionary which can optionally be used for communication between applications written for the PhidgetSBC, and
applications running on your local computer. This page lets you view and modify the Phidget webserice settings, as
well as stop and start the server. Please see the Advanced User’s Guide for more information on programming with
the dictionary.
Phidget Webservice
Enabled/Disabled
- Enables or disables the Phidget Webservice.
Server ID
- Server ID is used when opening a connection to the PhidgetSBC using the mDNS based openRemote
calls. This is by default the same as the PhidgetSBC hostname (phidgetsbc), but can be set to anything (up to 63
characters).
Port
- Port is the port that the webservice runs on - default is 5001.
Password
- The password is used for securing the webservice. By default, this option is disabled with a blank
password. Note that while the authentication protocol and password is encrypted during authentication, all following
data is sent in the clear.
Start/Stop
- Use this button to start/stop the webservice.
