Phihong USA Corporation
•
East Coast Engineering Center
•
630 Johnson Ave. Suite 102, Bohemia, NY 11716
•
Tel: (631) 610-2289
www.Phihong.com
or
www.Midspans.com
40
set traphost [n] [x.x.x.x]
Trap hosts are the destination IP addresses that you want the
Traps to be sent to. You can set the IP addresses in the
Controller Setup or HyperTerminal.
set traphost 1 192.168.1.112
set traphost 2 192.168.1.113
set traphost 3 192.168.1.114
set traphost 4 192.168.1.115
show port [n]
show port 1 ~ 24 (depending on the Midspan model)
show system
show system
Trapemu [port] [trap_number]
Trapemu 1~24 1~7 (select trap to emulate)
Trap numbers defined:
1
- poePortHWFailTrap
2
- poePortPeakOverCurrentTrap
3
- poePortOverloadTrap
4
- poePortDiscoveryFailTrap
5
- poePortClassificationFailTrap
6
- poePortDisconnectTrap
7
– PoePortVoltageFailTrap
? | help
?
After a specific change, the NIC Interface Midspan will automatically reboot. The IP address of
the NIC Interface Midspan may change, depending on your controller settings (DHCP client
Enabled). If you receive the message below:
Please use the Ethernet Manager Tool (
etm.exe
) to verify the IP address again.
For a quick verification of the functionality of the NIC Interface Midspan: