EN - 11
10/2014
Copyright © 2014, Fast ČR, a. s.
Whenever you want to move the appliance, remember to turn the feet back up so that the appliance can roll
freely. Reinstall the appliance when relocating.
CAUTION!
The rollers, which are not castors, should be only used for forward or backward movement.
Moving the refrigerator sideways may damage your fl oor and the rollers.
Cleaning before use
Check that you have removed from the appliance all adhesive tape used to hold accessories . Then clean all the
inside parts using lukewarm water with a neutral cleaning agent, vinegar or sodium carbonate – in this way
you will remove the characteristic odour of new parts – then dry carefully. Do not use detergents or aggressive
agents, which could damage the surfaces.
Electrical connection
Before connecting the power plug to the power socket, check that:
•
Your hands are completely dry.
•
The voltage and frequency shown on the rating label of the appliance corresponds to that in the home
power grid (permitted tolerance from -6 % to +6 % for nominal voltage, for use with diff erent voltages, use
a voltage converter with the corresponding parameters).
•
The power cord and the plug are not damaged or caught under heavy objects.
•
The power cord is not excessively tensioned; it is not permitted to use an extension cord.
Do not connect the appliance to a voltage rectifi er (e.g. solar power plant) or use an extension cord.
The appliance must be connected to a working grounding lead. If the power socket of the home system
is not grounded in accordance with the current legal regulations, only connect the appliance after consulting
with a specialised technician about the grounding lead itself. The manufacturer takes no responsibility for
injuries caused as a result of not following these instructions. If you do not correctly level the freezer during
the installation, the doors may not close shut and seal properly, which may cause problems with the cooling,
ice build up or moisture. Levelling the freezer is very important.
Reverse the door
The side in which the door opens can be changed from the right side (as supplied) to the left side, if the
installation site allows for it.
Tools you will need:
1. 8mm socket driver
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
