Copyright © 2019, Fast ČR, a. s.
Revision 12/2019
EN - 10
PART 3: UNPACKING YOUR REFRIGERATOR
WARNING!
Use two or more people to move refrigerator.
Failure to do so can result in back or other injury.
•
Remove tape and any labels from your refrigerator before using (except the rating label).
•
To remove any remaining tape or glue, rub the area briskly with your thumb.
•
Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your refrigerator.
•
When moving the refrigerator, do not tilt the refrigerator beyond 45° from upright position.
PART 4: CLEANING BEFORE USE
After you remove all of the packaging materials, (especially the foam between outside condenser and cabinet
should be removed) clean the inside of your refrigerator before using it.
PART 5: SPACE REQUIREMENTS
WARNING!
Keep flammable materials and vapors, such as gasoline, away form refrigerator.
Failure to do so can result in death, explosion, fine or burns.
•
To ensure proper ventilation for your refrigerator, allow for 200 mm space on each side between walls, 200
mm space between back of your refrigerator and the wall, and 300 mm space between counter top and
the roof or ceiling.
•
If you are installing your refrigerator next to a fixed wall, leave sufficient space on the hinge side to allow
for the door to swing open.
•
Never install your refrigerator near heat source and direct sun shins.
