EN - 13
02/2013
Copyright © 2013, Fast ČR, a. s.
Please be aware:
Compressor
The compressor is controlled by the thermostat, which is set by the temperature control knob, and turns itself
on automatically when temperatures inside the appliance is exceeded and then turns itself off as soon as it
again reaches this temperature. When any compressor – cooling system is turned on – noise can be heard.
These sounds are made when the motor in the compressor is working and they are also made by the coolant
circulating in the circuit of the cooling system. These noises are normal and do not indicate any malfunction in
the operation of the appliance.
In unheated rooms or in cold weather conditions condensate may form on the exterior walls of the appliance.
This does not indicate a malfunction and this condensate will disappear as soon as the temperature rises.
Contact the service department only when
, after analysing all possible factors of the malfunction you
cannot fi nd any cause for the malfunction or you are unable to remedy the malfunction yourself. So, fi rst focus
on: "
What should I do when
...."
NOTE:
The refrigerator is defrosted automatically during the refrigeration process. Water is drained through
an opening in the rear side of the refrigerator into an evaporation container, where it is automatically
evaporated. To ensure that the automatic defrosting function of the refrigerator works correctly, keep
the opening and the area around it clean and unclogged. If it becomes soiled, clean out this part without
delay, or pour 1/2 glass into the opening if necessary.
Changing a light bulb
All appliances equipped with a light have a switch installed. When the refrigerator is turned on using the
temperature control knob, the light will automatically come on when the door is opened and automatically
turn off when the door is shut.
Light bulb specifi cations: 220 – 240 V ~, max. 15 W
1. Turn off the appliance by turning the temperature dial to „0“.
2. Disconnect the power cord from the power socket.
3. Press the light bulb cover in the middle.
4. Take off the cover using a screwdriver and screw out the light bulb. Screw in a new one with the same
parameters.
5. Return the cover and turn the appliance on again.
Light bulb (inside)
Temperature dial
Light bulb cover
