32
Child-lock
When the machine is turned on, press the button for 3 seconds to open/close the child lock function. When the
button is turned on, the indicator light of the child lock is on. The indicator light of child lock is off; After the child
lock function is opened, the child lock function will be cancelled automatically as long as the shutdown or
power failure occurs
5.4 DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
5.3.1 EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once you empty the
water tank and installed properly.
1) When the tank is full, The unit will make a buzzing sound, and
the “Water Full” light will turn on.
2) Press the POWER button to turn off the unit.
3) Pull on the water tank and simply slide out of the body of the dehumidifier.
4) Empty the water into an area with a drain or outside.
5) Clean the inside of the tank as well as the outside.
6) Replace the empty tank back into the unit.
7) Press the POWER
button to resume operating.
8) If the Water Full light does not extinguish, check that the float is correctly in place.
Summary of Contents for TeraDry 20
Page 8: ...7 3 Επισκόπηση Προϊόντος ...
