Power
LED
YL3 Mains
Adaptor
External
Aerial
(sold separately)
External
Aerial
Downlead
ANT IN
TV
OUT
RF IN SCART/
HDMI
- OR -
Set-Top Box
Aerial Loop
RF Out
RF In
Variable
Gain Control
DC In
Integrated
Aerial Coax
Lead
-
Connects direct to
TV
ANT IN
if Freeview™
receiver built in
Aerial Coax
Lead
(not supplied)
Scart/HDMI Lead
(not supplied)
Features Include:
•
High gain and low noise built-in amplifier
•
Suitable for Digital TV in strong signal areas
•
Compact size
•
0-20dB gain
•
Adjustable gain control
Installation Instructions
1. Plug the integrated aerial coax lead (Fig. 1)
from the aerial into the antenna (RF) input
on your set-top box, or TV.
2. Connect a SCART lead from the SCART
output on your set-top box to your TV.
Alternatively, connect an aerial coax lead
(not supplied) from the RF output
on your set-top box to the aerial input
on your TV (if in doubt check the
instructions for your set-top box).
3. Switch on the variable gain control
and set to maximum amplification
(turn control clockwise as far as it will go).
4. Rotate and tilt the UHF loop antenna to
obtain the best reception (see Fig. 2 & Fig. 3).
5. Adjust gain control to obtain best picture signal.
Compact Amplified Indoor Aerial
Fig. 1
The
RF IN
coaxial socket on the back of the aerial
(See Fig. 1) allows an alternative video source, such
as an outdoor aerial, cable TV, a video game, or
satellite receiver to be connected to your TV via the
aerial. This saves you having to keep connecting and
disconnecting the coaxial cable running to your TV
and also saves wear and tear on the TV coaxial socket.
To select the signal from the aerial, switch on the
gain control. The red power LED on the front of the
aerial will light up, while this LED is lit the signal sent
to your TV will be from the indoor aerial. To switch to
an alternative video source connected via the
RF IN
coaxial socket simply switch off the gain control
(power LED is not lit).
Connecting an alternative RF source
Fig. 2
Fig. 3
27795R
UseR GUIde
