NOTE: For Digital Signals, this aerial should be
used in strong signal areas only.
1. if your TV has a built-in digital tuner,
connect your aerial to the RF input on
your TV using the coax cable supplied.
2. If you have a separate digital set top box
connect your aerial to the RF input on
your set-top box. Connect a 2nd coax
cable (not supplied) from the RF output
on your set-top box to the aerial input on
your television. Alternatively, connect a
SCART cable (not supplied) from the
SCART output on your set-top box to
your television (see Fig. 1).
3. To tune TV signal reception rotate and
tilt the UHF blade antenna to obtain
best reception (see Fig. 2 and Fig. 3).
4. For VHF signals fully extend telescopic VHF
antenna rods. Then adjust antenna angle and
rotate the whole aerial to obtain the best
VHF/FM/DAB signal (see Fig.4).
Assembly
1. To assemble your SLx digiTop aerial simply slide the
column supporting the UHF antenna blade into the
slots in the base until it clicks into position -
as shown opposite
Installation for unamplified aerial - 27768RG
Fig. 1
Fig. 2
Fig. 3
Fig. 4
ANT IN
TV
COAX CABLE
OUT
RF IN
SCART
- OR -
SET-TOP BOX
COAX CABLE
(not supplied)
HDMI/SCART CABLE
(not supplied)
HDMI
