Installation Steps
1. Connect the switch to the In +& -, or potentiometer, or various
sensors.
2. Connect Out +& - to controller load.
3. Connect Vdc +& - to 12-24VDC.
Fig 1. Assembling & Wiring
IMPORTANT
Installation must be performed by skilled technicians who are
informed about the standards and technical requirements of
the appliance and its proper installation.
Check your local codes as they apply to your situation. If the
house wiring is of aluminum, consult with an electrician
about proper wiring methods.
Before proceeding with the installation, TURN OFF THE
POWER TO THE LIGHTING CIRCUIT AT THE CIRCUIT
BREAKER OR FUSE BOX TO AVOID ELECTRICAL SHOCK.
For Instruction to http:// www.philio-tech.com
「
Danger of Electrocution
All works on the device may be performed only by a qualified and
licensed electrician. Observe national regulations. Any works
introducing changes into the configuration must be always
performed with disconnected voltage.
Choosing a Suitable Location
1.
Do NOT place the module/device direct under sunlight, in a
humid place or in any location where they may contact
moisture, dirt, dust.
2.
Do NOT place the module/device where exists combustible
substance or any source of heat, fires, radiators, boiler etc.
3.
When the module/device be used, the module/device might
get warm. This is a normal condition.
2
