Adding to Z-Wave
™
Network
There is a button with LED indicator in front of PAD18. It is used
to dim on/off the light and carry out the inclusion, exclusion, reset
or association of PAD18 from Z-wave controller.
When the fist power one, the LED indicator flashes once per
second for 30 seconds. With the SmartStart function, PAD18 will
be automatically included by Z-wave controller.
PAD18 can be operated with any certified Z-Wave™ devices
from different manufacturers in Z-Wave™ network. All non-battery
operating devices act as repeaters to increase the stability and
reliability of the Z-Wave™ network.
The table below provides an operation summary of basic Z-
Wave™ functions. To add/remove/associate PAD18, please refer
to the instruction of certified Z-Wave™ Primary Controller.
Function
Description
Annotation
Without Node ID
New PAD18 does not have Node ID until it is
included by a Z-Wave
™
Controller.
LED
light
flashes once per
second for 30
seconds.
Add
(Classic Inclusion)
1.
Set Z-Wave™ Controller to inclusion mode
by following the instructions provided by the
controller manufacturer.
2.
Press the button on PAD18 three times
within 3 seconds to enter inclusion mode.
SmartStart
1. To initiate the SmartSart process, please
type in the first five digits of DSK string or
scan the QR code. The QR Code can be
found on PAD18 or in the box.
Ex: DSK: 18112-24021- 48001-62259-
57092-27453-08187-47408
2. PAD18 is supported with SmartStart, it can
be added to Z-Wave™ network by scanning
the Z-Wave™ QR code on the product.
3. Without further actions, PAD18 will be auto-
matically included in a certified Z-Wave™
Controller with SmartStart inclusion ability in
10 minutes after it turned on.
Remove
(Exclusion)
1.
Set your Z-Wave™ controller to exclusion
mode by following the instructions provided
by the controller manufacturer.
2. Press the button on PAD18 three times
within 3 seconds to enter exclusion mode.
3. Node ID will be excluded.
LED light flashes
once per second
for 30 seconds.
Reset
1. Press the button of PAD18 four times within
3 seconds and hold the last press until the
LED light turns off.
LED light turns
on.
2. Once the LED light turns off, release the
button within 2 seconds.
LED light turns
off.
3. Device has been reset.
LED light flashes
once per second
for 30 seconds.
Adding a node ID allocated by Z-Wave™ Controller means inclusion.
Removing a node ID allocated by Z-Wave™ Controller means exclusion.
The situation of including/excluding of the node ID can be checked from the
Z-Wave™ Controller.
Function Reset: The Reset procedure can only be used when PAD18 cannot
be recognized by the Z-Wave™ Primary Controller.
3
