COMMAND_CLASS_DEVICE_RESET_LOCALLY
*
COMMAND_CLASS_POWERLEVEL
*
COMMAND_CLASS_BATTERY
*
COMMAND_CLASS_DOOR_LOCK
*
COMMAND_CLASS_USER_CODE
*
COMMAND_CLASS_ASSOCIATION_V2
*
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V2
*
COMMAND_CLASS_ASSOCIATION_GRP_INFO
*
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2
*
* Command Class Requires Security
XI. Simple Troubleshooting
1. After the installation of lockset and batteries, the door
cannot be locked, and three short beeps are emitted when
you press the Programming button.
Causes: The door-handling identifying process is not yet
complete.
Solution: Please execute the door-handling identifying
process as soon as the installation of the lockset is
completed.
2. After the installation of the lockset and batteries, no
responses when you press any button (no sounds are
emitted, and the back light does not work).
Cause: It could be a problem caused by the batteries or the
improper connection of the cable.
Solution: Check to see if the battery polarities have been
reversed or if the battery is dead. If so, please reinstall
or change the battery. If not, please check
if the cable is appropriately connected.
3. Fail in the first execution of the door-handling
identifying process (the red-light flashes three
times, and three short beeps are emitted).
Cause: Wrong door-handling or change of the door-handling
in the memory.
Solution: Press the R button to restore the system to factory
default setting and re-execute door-handling
identifying process.
4. Although succeeded in the first execution of the
door-handling identifying process, the latch does
not work. (Feeling that the motor runs powerlessly,
the latch bolt is stuck, and the turn-piece inside
cannot be rotated).
Cause: Low battery.
Solution: Please replace with new batteries.
5. The functioning has been normal, but suddenly, the
latch bolt locks up, and the turn piece inside cannot
be rotated, not even with key.
Cause: The detection of latch bolt position is abnormal.
Solution: Please take out one battery first, then press any button
on
the front panel for electric discharge, and put the battery
back next. The latch bolt will automatically re-detect its
position subsequently.
Attention: When the latch gets stuck frequency, please check if the
opening of the strike aims at the central position of the
latch bolt, if the latch bolt can stretch out freely, or if the
hinges are deformed or tilted.
6. The door can be locked normally, but three shorts
beeps are heard and the door would not unlock
when the user code is entered and the
programming button is pressed.
Cause: The functioning of the micro-switch is abnormal.
Solution: Please unlock the door with the keys first and then
contract
12
