I. Z-Wave function
“Enter PC” is enter “0000”(default)
function
description
Add
1.
check Z-Wave
TM
Controller entered
inclusion mode.
2.Press the Add/Remove function
3.After adding successful, it will have twice
beep sounds. if inclusion fail it will have five
beep.
Notice 1: if you reset doorlock, you have to do
OPERATING INSTRUCTION no.1(door
handling identification process)
Notice 2: if Door lock in learn mode,device can
stop on operation setting mode,until success
include or 60s time out.
Remove
1.
check Z-Wave
TM
Controller entered
exclusion mode.
2.Press the Add/Remove function
3After removing successful, it will have twice
beep sounds. if remove fail it will have five
beep.
Notice 1 : if you reset doorlock ,you have to do
OPERATING INSTRUCTION no.1(door
handling identification process )
Reset
1.Press the Restore function in section
OPERATING INSTRUCTION no.10
2.Device can send reset locally notification
note : Please use this procedure only when the
network primary controller is missing or
otherwise inoperable.
Lock
1.Z-Wave
TM
Controller use Command Class
Door Lock
2. Use Command Door Lock Operation Set
3.Set value to 0xFF, it means door secured.
unlock
1.Z-Wave
TM
Controller use Command Class
Door Lock
2. Use Command Door Lock Operation Set
3.Set value to 0x00, it means door unsecured.
Add
usercode
1. Z-Wave
TM
Controller use Command Class
User Code
2. Use Command User Code Set
3. Set User code ID, User code Status,
Usercode
note: User code ID range is 1~30,
User code Status 0x01, Usercode length is
4~10,
Remove
usercode
1. Z-Wave
TM
Controller use Command Class
User Code
2. Use Command User Code Set
3. Set User code ID, User code Status,
9
