three times.
3. After add successful, the device will wake to
receive the setting command from Z-Wave
TM
Controller about 20 seconds.
Remove
1. Have Z-Wave
TM
Controller entered remove mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the
remove mode.Node ID has been excluded.
Note: PSR03-C is removed by pressing panic key
three times.
Reset
1. Hold down the central key, then press the top-right
key four times within 1.5 seconds and do not
release the top-right key in the 4
th
pressed, and the
LED will light ON.
Note: PSR03-C is reset by pressing panic key four
times within 1.5 seconds and do not release the
top-right key in the 4
th
pressed.
2. After 3 seconds the LED will turn OFF, after that
within 2 seconds, release the keys. If successful,
the LED will light ON one second. Otherwise, the
LED will flash once.
3. IDs are remove and all settings will reset to factory
default.
Association 1. Have Z-Wave
TM
Controller entered association
mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the
association mode.
Note: PSR03-B supports 9 groups. Group 1 is for
receiving the report message, like AV controls, battery
status. Group 2 to group 9 are for lighting group
control, the device will send the “Basic Set” command
to these groups. And each group support 4 nodes
maximum.
PSR03-A supports 3 groups. The group 1 is for
receiving the report message. Group 2, 3 are for
lighting group control. Each group supports 4 nodes.
•
Including a node ID allocated by Z-Wave
TM
Controller means
“
Add
” or “
Inclusion
”. Excluding a node ID allocated by Z-
Wave
TM
Controller means “
Remove
” or “
Exclusion
”.
•
Failed or success in including/excluding the node ID can be
viewed from Z-Wave
TM
Controller.
Notice 1:
The device can not work normally in the first time.
Please
activate the battery before the first use.
Notice 2:
Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network.
Notice 3:
When the device into NWI mode, the NWI mode will timeout
after 30 seconds. You can Hold down the central key, then press the
top-right key three times within 1.5 seconds to abort the NWI mode.
Function Control
Remote PSR03 can control AV device via Z-Wave-to-IR extender and
lighting groups ON/OFF.
PSR03-B has five keys on the device. The central one has group-button
switching and special function, the others are control keys.
There are two group-buttons that can be switched by pressing central
key. When the device is switched to group-button 1, LED will light on
with red color for 3 seconds. When the device is switched to group-
button 2, LED will light on with green color.
PSR03-A has three keys on the device. The central one has panic
function and the others are control keys.
PSR03-C has panic function.