The lighting groups are not equal to association groups. The relation
between lighting groups and association groups is shown below.
Lighting Group Control
Group-Button 1
Top-left Key
Top-right Key
Bottom-left Key
Bottom-right Key
Lighting group 1 (Association group 2)
Lighting group 2 (Association group 3)
Lighting group 3 (Association group 4)
Lighting group 4 (Association group 5)
Group-Button 2
Top-left Key
Top-right Key
Bottom-left Key
Bottom-right Key
Lighting group 5 (Association group 6)
Lighting group 6 (Association group 7)
Lighting group 7 (Association group 8)
Lighting group 8 (Association group 9)
PSR03-A:
Only has one group-button which controls two lighting groups.
Lighting Group Control
Left Key
Right Key
Lighting group 1 (Association group 2)
Lighting group 2 (Association group 3)
Notice:
For switch AV control or lighting group control function please
setting the configuration No.7 bit 0.
Z-Wave
TM
Notification
After the device adding to the network, it will wake-up once per day in
default. When it wake-up it will broadcast the “Wake Up Notification”
message to the network, and wake-up 10 seconds for receive the
setting commands.
To wake-up the device immediately, please hold down the central key,
and press the top-right key once or just press the key once if the
device is PSR03-C. The device will wake-up 10 seconds.
Z-Wave
TM
Message Report
When the panic triggered, the device will report the trigger event and
also report the battery status.
* Panic Report:
When the central key is held down over
2
seconds, the device will
unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Emergency Alarm (0x0A)
Event: Contact Medical Service (0x03)
* Timing Report:
Beside the event triggered could report message, the device also
support the timing unsolicited report of the status.
•
Battery level report: Every 6 hours report once in default.
It could be changed by setting the configuration NO. 10.
•
Low battery report: When the battery level is too low, every 30
minutes will report once.
Notice
: The configuration NO. 10 could be setting to zero to disable
the auto report.
Activate the power
The device can not work normally in the first time. Please activate the
battery through micro USB before the first use. After the device is
activated by connecting to micro USB, the device will start charging and
LED will light on with red color. If the battery is full charged, LED will