2
6. User Code
6-1 The preset User Code is 1234. Please delete and create your
personal code when setting the lock for the first time.
6-2 Up to 6 User codes can be saved.
6-3 User Code is only for activating the lock, not for programming.
6-4 User Code can be deleted or changed anytime if needed.
7. Delete Individual User Code
7-1 User Codes can be deleted individually. You may reuse a User Code
even if they were deleted before.
7-2 To delete individual code, you need to enter the Programming code.
8. Delete All User Codes At Once
8-1 All the User Codes can be deleted at once. You may reuse same
User Codes even if they were deleted before.
8-2 Auto-locking and Keypad locking functionality will be invalid after
deleting all User Codes and the lock can only be operated by key
override. All the electrical functions will be restored after creating
new User Codes.
8-3 To delete all user codes, you need to enter the Programming code.
9. Temporarily Disable All User Codes
9-1 Auto-locking and Keypad locking functionality will be invalid when
User Codes are temporarily disabled. The lock can only be operated
by the key override during that time.
9-2 Repeat the programming steps again to restore the User Codes.
10. Create a Disposable User Code
10-1 Disposable user code can only be used one time and then they
are no longer valid.
10-2 You can reset same number as Disposal User Code.
10-3 To create a Disposable User Code, you need to enter the
Programming Code.
11. Restore Preset Factory Code
11-1 You can restore the lock to the Factory default codes by pressing
“R” button on the interior receiver module below the batteries if
you
forget the Programming Code or you want to cancel all
previous settings.
11-2 After resetting, the Programming Code would be 0000; the User
Code would be 1234 again.
12.
Unlocking the door
12-1 The door can be unlocked by key override or by entering a User
Code on keypad from outside or by the interior turn-piece from
the inside.
12-2 To unlock the door on keypad, enter the User Code and then
press the Programming/Enter button.
13. Lock the door
13-1 The door will be locked by key override or by pressing the
Programming Button on keypad from the outside or by the interior
turn-piece from the inside.
14. Incomplete Door Closing / Opening
14-1 If the latch bolt is not extended/retracted completely when it is
locked/unlocked by the keypad, you will see the LED flash red 3
times(twice) and hear 3 beeps (no beeps if the mute is on). You
will then need to enter the user code to unlock the door to fully
retract the bolt and then press the Programming/Enter button to
lock the door again.
14-2 If the latch bolt gets stuck or can’t extend/retract completely all
the time, please check if the strike aligns with the latch bolt
perfectly and adjust the strike to proper position. After long period
of use, the latch bolt might get stuck if the door becomes
misaligned.
