3
15. To Activate / Deactivate Auto-Locking Function
15-1 The door will automatically lock itself within 10-99 seconds when
this function is activated.
15-2 This function is NOT preset default; it can be set if needed.
15-3 The preset delay-time is 30 seconds; you can adjust the period if
desired.
15-4 Repeat the same programming steps to cancel Auto-Locking
function if needed.
15-5 The system will beep twice if the latch bolt gets stuck or is not
extended/ retracted completely. If this occurs, you will need to the
User Code again to retract the bolt completely. The auto-locking
function will then be restored.
16. Toggle Mute On/Off
16-1 You will hear beep sounds when pressing keypad, programming or
after incorrect errors. The sound can be turned off if needed.
16-2 LED illumination is still functioning even when mute is enabled.
Because you will not hear any alarms for battery indication or
incorrect entrees, we suggest not enabling mute if it is not
necessary.
16-3 The motor sound cannot be muted.
17. Code Protection Function
17-1 The lock will go into lockout mode after 5 incorrect usercode
entries in a row. Lock Out mode will expire after 45 seconds.
18. Illumination
18-1 The LED Keypad will light up when pressing any button for ease of
use in the dark.
19. Include/Exclude To Z-Wave
TM
Network
19-1 After installing the PSA01 on the door and placing the battery in, it
is ready to be added to Z-Wave network. Be sure PSA01 is not in
any other Z-Wave network. If you don't know, just run exclusion
first.
(Refer to part V 11 section),
20. Z-Wave
TM
Specification
20-1 frequency
868.40 MHz, 869.85 MHz(EU),
908.40 MHz, 916.00 MHz(US),
922~927 MHz(JP/TW),
921.40 MHz, 919.80 MHz(ANZ),
869.00 MHz(RU),
865.20 MHz(IN),
916.00 MHz(IL),
20-2 Range
Minimum 40 meters indoor,
90 meters outdoor line of sight.
20-3 Operating Temperature
-10
o
C ~ 40
o
C
II. Installation Instructions
The BACKSET is the distance between the
center of cross bore and edge bore of the
door. Adjustable latch fits both BACKSET of
2-3/8
"
(60mm) and 2-3/4
"
(70mm). Please
follow the steps shown below for BACKSET
adjustment.
