5
a. To identify the center of strike:
Close the door, on the basis of the
faceplate mark horizontal center line of
strike.
Ensure the center of faceplate and the
enter of strike are aligned.
Use the mark as a guide outlines the
strike.
b. Chisel 5/64
"(2mm) deep along the strike
outline to allow the strike to be aligned
with the doorframe.
c. Insert the strike and tighten it with
screws.
Note: please use tapping screws for
metal door.
4. Install Strike
5. Install Keypad Assembly
a. Ensure that the latch bolt is retracted.
b. Please refer to the diagram below for Cylinder Installation.
Place deadbolt against keypad with tailpiece in horizontal position
inserted through hub of the latch.
c. Pass the IC wire under the latch to the interior side of the door.
6. Install Inside Mounting Plate
Pass the IC wire through the
wire hole of the mounting
plate.
Fix the mounting plate with
screws.
If outside lock assembly is
lopsided, please loosen the
screws to adjust its position
and tighten the screws again.