7
1.
Programming/Enter Button
Programming/Enter Button is utilized for unlocking the door after
entering the user codes, clearing errors and programming the lock.
It’s also lock button.
2. Number Buttons
Enter the user codes (4-10 digits in length) and program the lock
via number buttons.
3. Cylinder
Lock or unlock the latch bolt by key from exterior.
4. Washer
Protects the lock from water damage.
5. Battery Lid
Slide the lid to change the batteries or access reset button.
6. Battery Holder
Uses 4 AA (1.5V) alkaline batteries.
7. R Button Holder
Restore default setting.
8. Turn-Piece
Retract/Extend the latch bolt from interior.
III. Pass Code & Function Set up
1. Keep the lock in the unlock position while programming.
2. Run the door-handling identifying process (Refer to programming
table) before function set up when installing for first time or
restoring default setting.
3. Please change default Programming Code (0000) and User Code
(1234) when setting up for the first time.
4. LED flashes orange slowly while programming. Upon a correct input,
LED flashes green twice with 2 long beeps. LED flashes red 3 times
with 3 beeps when incorrect input.( If a mistake is made during
programming, wait for 6 seconds or press programming button to
clear then program again.)
5. Do not pause longer than 6 seconds while programming or you will
need to start again.
6. You can lock/unlock this product by either key override or user code.
Please refer to the following programming table for function set up.
