9
9. Enable/Disable All User Code
Remark: Auto-locking and keypad locking functionality will be invalid
when User Codes are deleted. The Lock can only be
operated by key override during that time. Repeat the
steps to enable the User Codes again.
10. Create a Disposable User Code
Remark: Disposable code will be no longer valid once being used.
11. Include/Exclude to Z-Wave Network
Remark: If you are not sure if the device has been included, just
exclude it first then include. If it has been included or
excluded successfully, it will beep twice, and LED will flash
green light twice.
12. Restore all preset lock settings
Remark: Press “R” button under the battery cover for over 5
seconds. After you hear 3 long beeps, the lock will reset to
factor default settings. After resetting, you must run the
door-hand identifying process before re-programming.
VI. Z-Wave function
Function
Description
Include
1.
Have Z-Wave
TM
Controller entered inclusion mode.
2.
Press the Include/Exclude function in part V 11
section.
3.
If included successfully, it will beep twice, and LED
flashes green twice.
Exclude
1.
Have Z-Wave
TM
Controller entered exclusion mode.
2.
Press the Include/Exclude function in part V 11
section.
3.
If excluded successfully, it will beep twice, and
LED flashes green twice.
Reset
1.
Press the Restore function in part V 12 section
Lock
1. Z-Wave
TM
Controller use Command Class Door Lock
2. Use Command Door Lock Operation Set
3. Set value to FF, it means door secured.
Unlock
1. Z-Wave
TM
Controller use Command Class Door Lock
2. Use Command Door Lock Operation Set
3. Set value to 00, it means door unsecured.
•
Failed or success in add/remove the node ID can be viewed
from Z-Wave
TM
Controller.
Notice 1:
Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network.