11
English
4 Assembling the
electric breast
pump
To assemble the pump, follow the
steps below.
Note
•
Make sure that you clean and
sterilise the pump as instructed in
this user manual.
•
Make sure that you assemble the
pump correctly as instructed in
this user manual.
•
To avoid leakage, remove the
residue around the rim before
assembling. Put the bottle onto
the pump body, and do not over-
tighten.
•
Wash your hand thoroughly
before you take sterilised
components.
1
Insert the valve into the pump
body from underneath. (Fig. 3)
2 Put the bottle onto the pump
body and turn it anticlockwise to
fix it. Do not over-tighten when
assembling the bottle to the
pump body. (Fig. 4)
3 Insert the Let-down Massage
Cushion into the pump funnel
and press the rim to ensure a
perfect seal. (Fig. 5)
4 Put the silicone diaphragm onto
the pump body and press the
rim to make sure a perfect seal.
(Fig. 6&7)
Tip
•
You may find it easier to
assemble while it is wet.
5 Firmly push the cap onto the
silicone diaphragm, so that it
sites securely on top of the
silicone diaphragm. (Fig. 8)
6 Connect the silicone tube to the
cap and the motor firmly. (Fig. 9)
7 Connect the power adapter to
the pump motor, and then insert
the power plug to the power
socket. (Fig. 10)
Note
•
Only use the adapter provided
with this product. Do not use
other adapter.
Tip
•
For battery operation, open the
rear cover of the motor unit in the
direction indicated by the marks.
Insert four new 1.5V AA alkaline
batteries into the battery housing.
Reattach the rear cover to the
motor unit. We recommend you
to use rechargeable batteries for
long time use. (Fig. 11)
Note
•
If you have inserted batteries in
the battery housing of the pump
motor and plug in the adapter,
the breast pump will run from the
main power supply. The batteries
cannot be charged in the unit.
