POWER SUPPLY
8
English
For the set (optional)
Open the battery compartment of the set and insert 6 batteries,
type
R20
,
UM-1
or
D
-cells (preferably alkaline).
For the remote control (AZ 1205 only)
Open the battery compartment of the remote control and insert 2
batteries, type
R03
,
UM-4
or
AAA
-cells (preferably alkaline).
Remove batteries if they are dead or if the set is not going to be
used for a long time.
Batteries contain chemical substances, so they should be
disposed of properly.
1
Check whether the voltage as shown on the type plate
corresponds to your local voltage. If it does not, consult your
dealer or service organization.
The type plate is located on
the bottom of the set.
2
If the set is equipped with a VOLTAGE selector
X
, set this
selector to the local voltage.
3
Connect the AC power cord to the AC MAINS socket and to the
wall socket. This switches on the AC power supply.
The AC
power cord is inside the battery compartment.
The battery supply will be switched off when the set is connected
to the AC power. To change to battery supply, disconnect the AC
power cord from the unit’s AC MAINS socket.
To disconnect the set from AC power completely, remove the AC
power cord from the wall socket.
X
AC power supply
Batteries
The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
