18
DDC Instructions
107S2 CM23 GSIII
4. Configuration and procedure
Following descirptions are the connection and procedure for Software
DDC, the main EEPROM can be re-programmed along with Software
DDC by enabling "factory memory data write"function on the DDC
program (EDID301.EXE).
Initialize alignment box
In order to avoid that monitor entering power saving mode due to sync
will cut off by alignment box, it is necessary to initialize alignment box
before running programming software (EDID301.EXE). Following steps
show you the procedures and connection.
Step 1: Supply 8~12V DC power source to the Alignment box by
plugging a DC power cord or using batteries.
Step 2: Connecting printer cable and video cable of monitor as Fig. A
Step 3: Run the EDID301.EXE program until the main menu appears.
This is for initialize alignment box.
5. DDC re-programming instructions
Start on DDC program
Start Microsoft Windows.
1. Insert the disk containing EDID301.EXE program into floppy disk
drive.
2. Click
, choose Run at start menu of Windows 95/98.
4. At the submenu, type the letter of your computer's floppy disk drive
followed by :EDID301 (for example, A:\EDID301, as shown in Fig. 5).
Fig. 5
Re-programming Software DDC
Step 1: After initialize alignment box, connecting all cables and box as
Fig. 3
Step 2: Follow the steps on DDC re-programming instructions to staring
re-programming.
~~
PC
To
video
card
To
printer
port
(L
TP1)
DC Power
8~12 V
Fig. 3
Printer
Port
To
Monitor
To PC
Rear view of the monitor
Video cable
~~
PC
To
printer
port
(L
TP1)
DC Power
8~12 V
Fig. A
Printer
Port
To
video
card
To
Monitor
To PC
Video cable
Rear view of the monitor
A:\edid301
ô
http://jdwxzlw.5d6d.com/?fromuser=华盛维修
家电维修资料网，免费下载各种维修资料
