EN-38
TV channel issues
9�2
Previously installed channels do not
appear in the channel list:
Verify that the correct list is selected.
•
The channel may have been uninstalled to
•
the
Rearrange
menu. To access the menu,
press
MENU
on the remote control and
select
Install
>
Channel installation
>
Rearrange
.
No digital channels were found during
the installation:
Verify if the TV supports DVB-T in your
•
country. See the listed countries on the
back of the TV.
Picture issues
9�3
The power indicator is on, but there is no
picture:
Verify if the antenna is connected properly.
•
Verify if the correct device is selected.
•
There is sound but no picture:
Verify that picture settings are correctly set.
•
See
Section 5.3 Adjust picture settings
.
You receive poor TV reception from an
antenna connection:
Check that the antenna is properly
•
connected to the TV.
Loud speakers, unearthed audio devices,
•
neon lights, high buildings or mountains can
influence the picture quality. Try to improve
the reception quality by changing the
antenna direction or moving devices away
from the TV.
Verify if the correct TV system is selected
•
for your region. See
Section 6.2 Manually
install channels
.
If reception on only one channel is poor,
•
try to fine tune this channel. See
Section 6.2
Fine tune analogue channels
.
Troubleshooting
9
This section describes commonly-encountered
issues and accompanying solutions.
General TV issues
9�1
The TV does not switch on:
Unplug the mains cord, wait for one minute
•
and plug in the mains again.
Verify that the mains cord is properly
•
connected and that the mains are powered.
The remote control is not working
properly:
Verify that the remote control batteries
•
are correctly inserted according to the +/-
orientation.
Replace the remote control batteries if
•
they are flat or weak.
Clean the remote control and TV sensor
•
lens.
You forgot your code to unlock Auto
Lock
Enter ‘0711’ as described in
•
Section 5.7 Lock
TV channels or connected devices (Auto Lock)
.
The TV menu is in the wrong language
See
•
Section 6.1 Automatically install channels
for instructions on how to change the TV
menu to your preferred language.
When turning the TV on/off/to standby,
you hear a creaking sound from the TV
chassis:
No action is required. The creaking sound
•
is normal expansion and contraction of the
TV as it cools and warms up. This does not
impact performance.
You forgot your code to unlock Auto
Lock
Enter ‘0711’ as described in
•
Section 5.5 Use
advanced teletext features (Auto Lock)
.
