EN-24
Customize your TV
6.5
Set preferences
When preferences are configured, they remain
in operation until they are reconfigured.
Press
1.
MENU
on the remote control and
select
Installation
>
Preferences
.
The
Preferences
menu appears.
Display program number permanently or not.
Tick the box: </> keys.
Return
Language
MaximumTV volume
Power Savings Mode
English...
Program number
Preferences
Press
2.
EXIT
to close the menu.
Select
3.
Return
and press
OK
to return to
the
Installation
menu.
Description of preferences
Program number
•
: Permanently displays
the number of the program being watched.
To enable the function, press
Í
,
Æ
or
OK
to check the box.
Language
•
: Press
Í
or
Æ
to select the
menu language.
Note
D
When you select a language, it is applied to
the menus immediately.
Maximum TV volume:
•
Sets the
maximum volume. Press
Í
or
Æ
to set the
volume. To hear the level that you have just
set, press the
OK
button and hold it for a
few seconds.
Power Savings Mode
•
: When this mode
is active the TV set automatically goes
into standby mode after ten minutes if it
does not receive any signal on the selected
program. To enable the mode, press
Í
,
Æ
or
OK
to check the box.
Configure AV sockets
You can configure your TV according to the
equipment you connect to it.
Press
1.
MENU
on the remote control and
select
Installation
>
Input settings
.
The
Input settings
menu appears.
S
elect the name of the device connected
Return
EXT 1 video input
EXT 2-YPbPr name
CVBS...
EXT 2
EXT 2-CVBS name
EXT 3 name
HDMI name
PC name
EXT 2
EXT 3
HDMI
PC
E
EXT 1 name
EXT 1
Input settings
Use the messages on screen and the following
instructions to configure the AV sockets.
EXT 1 name
•
:
If required, change the name as follows:
Press
•
Æ
to select
EXT 1_ _ _
.
Press
•
Î
and
ï
to select a letter, number
or symbol.
Press
•
Æ
to go to the next character.
Repeat the above steps until the name
•
is set.
Press
•
OK
to confirm.
EXT 1 video input
•
: Press
Í
or
Æ
to
select the type of video signal transmitted
by the equipment connected to the
EXT 1
socket. Select
RGB
if no picture
is displayed when you connect a games
console.
