18
EN
Enabling or disabling EasyLink
Once an HDMI-CEC compatible device has
been switched on, the TV will automatically turn
on and switch to the correct signal source.
Note
•
Do not enable this function if you would prefer not to
use Philips EasyLink.
1
Press
(Home)
and select
[Setup]
to
enter the
[Setup]
menu.
2
Press
to select
[EasyLink]
>
[HDMI CEC]
.
3
Select
[Off]
or
[On]
, then press
OK
.
Using One-touch Play
1
Once EasyLink has been enabled, press
play on the device.
»
The TV will automatically switch to the
correct signal source.
Using One-touch Standby
1
Press (
Standby/On
) on the remote control.
»
The TV and all connected HDMI
devices will automatically enter standby
mode.
•
VGA cable
VGA
VGA
AUDIO IN
VGA / DVI
Using Philips EasyLink
Making full use of your Philips EasyLink HDMI-
CEC compatible devices can enhance control
features to achieve the best possible results.
HDMI-CEC compatible devices connected
through the HDMI connector can be controlled
by a TV remote control.
To enable Philips EasyLink, you will need to:
•
Connect two or more HDMI-CEC
compatible devices using HDMI
connections.
•
Make sure that each HDMI-CEC
compatible device is operating normally.
•
Switch to EasyLink.
Note
•
EasyLink compatible devices must be switched on and
selected as a signal source.
•
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.