14
English
OK
Store
Settings assistant
You have set up your viewing preferences.
Exit
MENU
BACK
Back
5
Use ▲▼ to select
Antenna
for TV channels or
Cable
for CATV
channels, then press
OK
.
Setup Wizard (3/6)
Please select TV RF tuning band
Antenna
Other source
Cable
Previous
Cancel
Select
OK
OK
Cable
– When
Antenna
is selected, the TV detects antenna signals. It searches
for DTV and Analog TV channels available in your area.
– When
Cable
is selected, the TV detects signals supplied by cable. It
searches for DTV, Analog TV and Cable channels available in your
area.
•
Autoprogram
will begin.
Setup Wizard (4/6)
Please check that the RF cable is connected properly.
Scan time may take over 20 minutes.
Select
OK
OK
START
Previous
Cancel
Setup Wizard (5/6)
Searching. Please wait
Searching CH
Digital Channels Found
Analog Channels Found
Channel 1
0
0
0%
Exit
MENU
Setup Wizard (6/6)
Congratulations. TV Setup is done.
Exit
MENU
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press during AutoProgram, this setup of TV channels will be canceled.
• The initial AutoProgram function can be executed for either
Antenna
or
Cable
only
once. When you change the connection (Antenna / Cable), set
Autoprogram
again.
p. 21
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram
p. 21
• If you want to change to another language.
Language
p. 22
• If you want to change the location setting.
Location
p. 26
• If you want to restore the picture setting.
Settings assistant
p. 18