33
En
gl
is
h
EN
[Low power standby]
The Low power standby option defines the TV to enter
a specific standby mode after pressing the On/Off
button on the remote control. To wake-up the TV both
On/Off button on the RC or TV can be pressed:
[Fast]:
The TV will quickly turn on (show startup
channel.
(This mode is having more power
consumption then the Green mode).
[Green]: The TV will slower turn on (show startup
channel) then the Fast.
(This mode is having
less power consumption then the Fast mode).
[Smart power]
The power consumption for the Smart power mode is
defined by the
Standard
Smart Picture setting in the
TV Setup part.
[Off]:
The TV will start with Standard Smart
Picture setting, but the setting can be
changed in the guest setup mode.
[On]:
The TV will start with Standard Smart
Picture setting and Smart Picture setup is
not selectable in the guest setup
mode.
(with this the power consumption mode is
predictable)ng less power consumption then the
Fast mode).
[Clock settings]
[Display Standby]
Defines the brightness level for the Clock LCD
backlight if the TV is in Standby mode:
[Set]:
Off, 1, 2, 3, 4, 5
[Display On]
Defines the brightness level for the Clock LCD
backlight if the TV is in On mode:
[Set]:
Off, 1, 2, 3, 4, 5
[Time Setting]
This is only available if the Time Download is set to
Manual and can be used to set the clock with the
remote control:
[Set]:
Time entry field [xx:xx Hr]
Time to be set by using arrow keys and numeric buttons
[Time Download]
Select source for clock time:
[Automatic]:
During cold start the Clock time is
retrieved from the Download Program
channel before displaying the tuned
channel.
During a ‘going to Standby cycle’, the
clock time is updated as well.
[Manual]:
The clock time is set using the Time
Setting option.
[Country dependent]:
During cold start the Clock time is
retrieved from the Download Program
channel before displaying the tuned
channel, and country dependent settings
are made (UTC+LTO).
During a ‘going to Standby cycle’, the
clock time is updated as well.
[Time Offset]
Offset time added to the downloaded clock time:
[Slider]:
-12 to 12 hr
[Buzzer Volume]
Volume level of the Clock Time Alarm level:
[Set]:
Off,
Low
, High
[Feature settings]
[Multi RC]
This function allows that up to four televisions can be
installed in a room whereas every TV will listen to its
own RC. Once the TV is set, also every RC can be
set to remember its connected TV
:
[Off]:
This function is not used; all TVs will
listen to a ‘blue’ RC.
[Blue]
The TV will listen to a ‘blue’ RC.
Press and hold the blue button for two seconds.
[Green]
The TV will listen to a ‘green’ RC.
Press and hold the green button for two
seconds.
[
Yellow]
The TV will listen to a ‘yellow’ RC.
Press and hold the yellow button for two
seconds.
[Red]
The TV will listen to a ‘red’ RC.
Press and hold the red button for two seconds.
[MyChoice]
With MyChoice it is possible to activate two channel
rings: R0 when MyChoice PIN is valid, and R1 if not.
[Off]:
Single channel map as configured during
channel installation.
[On]
Channel ring R0 to be available to guest
in case of valid PIN entered; R1 if not.
[ThemeTV]
With ThemeTV it is possible to activate a
customizable UI to select upto 15 different themes
that contains Channle references. ThemeTV can be
presented on the display by means of pressing the
ThemeTV button on the RC, or automatically after
starting up the TV:
