Mechanical Instructions
4.
4.2
Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and
never
only the
display.
Caution:
Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning:
Disconnect the mains power cord before removing
the rear cover.
Attention:
Sets in the 7000 & 8000 range are equipped with a
hatch to disconnect the keyboard control panel and/or
Ambilight units. Ambilight sets in the 5x00 range are equipped
with a hatch to disconnect the Ambilight units.
These hatches are indicated on the rear cover with
SERVICE
h
.
It is mandatory to open the hatches and disconnect the
cables prior to removal of the rear cover!
1.
For sets in the 5x000 range equipped with Ambilight: open
the hatch that covers the Ambilight connector and unplug
the connector; see
. Remove the screw [1], lift
the connector [2] and slide the cable upwards [3].
2.
For sets in the 7000 & 8000 range: open the hatch that
covers the leading edge and unplug the connectors; see
.
3.
Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
Figure 4-14 Rear cover removal - back cover hatch
Figure 4-15 Rear cover removal - leading edge hatch
Refer to
for screw positions.
19510_104_1
3
0424.ep
s
1
3
0424
2
3
1
19510_105_1
3
0424.ep
s
1
3
0424
