Philips 40PFG6309 User Manual Download

Page: 32 / 80

12.1

What you need

This is an Active 3D TV. On this TV, you can watch 3D
programs and movies in full High Definition resolution with
Active 3D.

To watch 3D you need to :

• Tune to a TV channel that broadcasts programs in 3D
• Rent a movie in 3D from an online video store with Smart TV
• Watch a movie in 3D from a 3D Blu-ray Disc, a USB device,
or computer

To also watch in 3D on this TV, you will need one of these
types of Philips Active 3D glasses. . .

• PTA507
• PTA508
• PTA509
• PTA517
• PTA518
• PTA519

All types are sold separately. Other active 3D glasses might not
be supported.

12.2

The 3D glasses

Overview

1 -

On or off switch

2 -

Player 1 or player 2 selection

3 -

Receiver lens

4 -

Battery compartment

When you unpack the 3D glasses, also remove the small plastic
foil from the battery compartment that prevents the battery
from running empty.

Turn on and off

Turn on

When a 3D program is shown on screen, press



on the 3D

glasses and put them on. The glasses need some seconds to
adjust to the 3D signal from the 3D transmitter on the TV. At
first use, this may take up to 15 seconds.

Battery level

You can check the battery level when you turn on the 3D
glasses.

• If the LED light blinks green, you can use the glasses for 4
hours or more.
• If the LED light blinks orange, you can use the glasses for at
least 2 hours but less than 4.
• If the LED light blinks red, the battery is almost empty and less
than 2 hours of 3D watching remain.

Turn off

To turn off the 3D glasses, press



. The LED light blinks red 4

times. When the 3D glasses do not receive 3D signals for 2
minutes, the glasses turn off automatically.

3D transmitter

Make sure the receiver lens in the center of the glasses can
receive the 3D signals. Also, clear objects away from the 3D
transmitter on the TV.

1 -

3D transmitter on the TV

2 -

3D receiver on the 3D glasses

Two-player gaming

You can use these glasses to play two-player games. Two players
can watch the same TV but see two different screens to play a
game.
To switch the glasses to watch the Player 1 or Player 2 screen,
turn on the glasses and then press the

Player 1/2

key.

• If the LED light is orange and is lit up continuously for 2
seconds, the glasses are set for player 1.
• If the LED light is orange and blinks, the glasses are set for
player 2.

For more information, press



Keywords

and look up

Two-

player gaming

Replacing the batteries

To replace the battery of the 3D glasses PTA508, unscrew the
small battery lid and replace the battery: type CR2032 (3V).
Make sure the + side of the battery is visible. Replace the lid and
fix it with the screw.

To replace the battery in the PTA509 or PTA519 3D glasses,
press the small knob on the battery lid and slide the lid up to
open. Replace the battery with a type CR2032 (3 V)
replacement. Make sure the + side of the battery is visible.
Replace the lid and slide it down until it clicks.



Warning

Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.

Danger

• Do not ingest the battery. Chemical burn hazard.