Mechanical Instructions
4.
Figure 4-3 Rear cover removal
4.3.2
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from both the LVDS cables/Flat Foils
connectors that connect to the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Release the clamps and unplug all other connectors [2].
3.
Remove all fixation screws [3] from the SSB.
4.
Take out of the SSB. Refer to
for details.
Figure 4-4 SSB removal
4.3.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Unplug power connector from the SSB.
2.
Unplug all other connectors from the PSU.
3.
Remove all fixation screws from the PSU.
4.
The PSU can be taken out of the set now.
19170_102_110706.eps
110713
1
M4 × 12
3
M3 × 6
3 × 10
2
1
1
1
1
2
2
2
2
2
2
2
2
2
2
2
2
2
3
3
3
19170_103_110706.eps
110713
3
3
3
1
3
2
