Mechanical Instructions
4.
Figure 4-17 Keyboard removal
4.4.4
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
Unplug the cable/flat foils connector.
2.
Unplug all other connectors [2].
3.
Remove all the fixation screws from the SSB [3].
4.
Take out the SSB with I/O bracket.
5.
The SSB can now be shifted away from side connector
cover, then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-18 SSB removal
20151_105.eps
2
1
1
20151_106.eps
1
3
3
3
3
2
2
