Mechanical Instructions
4.
4.5.3
AmbiLight Panel
Refer to
for details.
1.
Gently release the clamps and unplug the connectors [5]
that secure the ambilight panels. Release the clips from the
FFC connector that connect with the Keyboard control
panel [4].
2.
Lift the AmbiLight panel from the rear cover. Make sure that
wires and flat foils are not damaged while lifting the
Ambilight panel from the rear cover.
Figure 4-24 Ambilight and Keyboard removal
4.5.4
Keyboard Control Unit
Refer to
for details.
1.
Release the connector [2] from the SSB Board, then
release the connectors [3] from the Ambilight panel.
Caution: be careful, as these are very fragile connectors!
2.
Remove all the fixation screws from the keyboard control
panel [1] and take it out from the Back cover.
When defective, replace the whole unit.
4.5.5
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
Unplug the cable/flat foils connector.
2.
Unplug the FFC cable[2] and other connectors [3].
3.
Remove all the fixation screws from the SSB [4].
4.
Take out the SSB with I/O bracket.
5.
The SSB can now be shifted away from side connector
cover, then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-25 SSB removal
20152_105.eps
3
2
3
4
4
5
5
1
1
5
5
5
5
20152_106.eps
1
4
4
4
4
4
4
3
2
3
