7
EN
Channel installation
This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
46HFL3683S / 40HFL3683S
Cable
ANT. IN
32HFL3663S
Cable
3
Turn the TV on.
• Press
.
POWER
at the side of the TV or use the
.
(POWER)
on the remote control.
46HFL3683S / 40HFL3683S
32HFL3663S
4
Press
RC5 SETUP
to put the remote control into setup
mode, then press the
HOME/MENU
button to display
the setup menu. (Hereafter,
HOME/MENU
will be simply
referred to as
MENU
)
5
Select
[Consumer TV setup]
-
[Setup]
-
[Autoprogram]
;
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Note
•
The TV will not tune any channel that has not been
fi
rst “installed”. This
includes SPI direct tune commands!
