9
EN
Con
fi
gure the Switch on settings
1
Press
MENU
and select
[Switch on settings]
.
2
Press
Î
or
ï
to select the desired mode, then press
OK.
•
[Switch on volume]
: De
fi
nes the pre-set volume level
when TV is powered on.
•
[Maximum volume]
: De
fi
nes the maximum limit of
volume level.
•
[Switch on channel]
: De
fi
nes the power-on channel
number or external video input.
•
[Power on]
: Determines the state of the TV when the
AC power is provided or restored.
•
[On]
: Powers on TV after the AC power is
restored. (digital signage application)
•
[Standby]
: TV enters standby mode. (hospitality)
•
[Last status]
: Returns TV to the same state as
before power was interrupted. (general use)
Con
fi
gure the Control settings
1
Press
MENU
and select
[Control settings]
.
2
Press
Î
or
ï
to select the desired mode, then press
OK
.
•
[TV RC locked]
: Sets the TV operative or inoperative
by guest remote control.
•
[TV keys locked]
: Sets the TV operative or inoperative
by local keyboard.
•
[On]
: The control buttons on the TV are disabled
except for the Power button.
•
[Off]
: The control buttons on the TV are enabled
and function normally.
•
[All]
: All the control buttons on the TV are
disabled including the Power button.
•
[OSD display]
: Enable or disable to display the “On
Screen Display”. When you select
[Off]
, those settings
below cannot be displayed on TV.
- volume bar
- channel number / label / name
- “channel not valid” information
The rest of menus such as CC, Guest menu, Setup
Menu, Status Menu, Splash Screen, Sleep Timer, Sleep
warning Message, Freeze, Child lock Message and USB
Media Playback menu, etc. are still displayed.
•
[EcoPower]
: Sets the TV to reduce the power
consumption.
•
[SPI Port]
: Choose the SPI port connected to the
external set top box.
•
[Off]
: SPI Port is disabled.
•
[3V3]
: SPI Port is enabled with the data and clock
line being pulled high to 3.3V voltage idle.
•
[5V]
: SPI Port is enabled with the data and clock
line being pulled high to 5V voltage idle.
•
[Standby mode]
: Choose the standby mode when the
TV goes into the standby mode. When
[SPI Port]
is
switched to
[3V3]
or
[5V]
,
[Standby mode]
should
be set to
[Fast]
to support all the relevant SPI Port
commands.
•
[Green]
: While the TV is turned off in this mode,
the SPI functionality is limited. Once turned on,
complete SPI functionality is restored.
Refer to the full User Manual for more complete
information.
•
[Fast]
: While the TV is turned off in this mode,
complete SPI functionality is maintained.
•
[USB playback]
: Enable or disable to support the
feature of the USB media playback. The USB cloning
feature is always enabled, regardless of this setting.
Supported USB Playback formats:
<JPEG>
• Upper limit
: 24Mpixel
<Motion JPEG>
• Size
: 320 x 240 (QVGA)
• Frame rate
: 30fps
• Audio type
: LPCM - Sampling frequency
-
(32 kHz, 44.1 kHz or 48 kHz)
- Quantization bit rate (16 bit)
