Update software
Philips continuously tries to improve its products and we strongly
recommend that you upgrade the TV software when upgrades are
available.
New software can be downloaded from our website at
www.philips.com/support
using the model number of your TV to find
information.
You can update the software through these methods:
•
Update with USB memory stick
•
This section describes how to upgrade the software by using USB memory
stick.
Preparing for the software upgrade
You require the following equipment:
–A PC with web browsing capability
–An archive utility that supports the ZIP-format
(e.g. WinZip for Windows or StuffIt for Mac OS)
–An empty clean formatted USB memory stick
Note(s)
•
Only FAT / DOS-formatted portable memory is supported.
•
Use only software upgrades that can be found on the Philips web site.
Warning
•
When the software upgrade is running, don’t press any buttons.
•
Do not remove the USB memory stick during the software upgrade.
•
If an error occurs during the upgrade, retry the procedure or for further assistance, please contact
call center.
Downloading the software
Find information and software related to your TV and download the latest
software upgrade file to your PC.
Prepare a blank USB memory stick for software update. Access
www.philips.com/support
and download the latest version software to
a blank USB memory stick using a PC by following the directions described
on the website.
•
Use a blank USB memory stick, download the software on your PC and
write the software in the root directory of the USB memory stick.
•
For more details on how to download the software, please refer to the
website.
USB upgrade
You can upgrade the software by using USB memory stick.
1
Connect your USB memory stick with the upgrade file to the USB
terminal on the side of your TV.
2
Press
and use
to select
Setup
, then press
OK
.
3
Use
to select
Update software
, then press
OK
.
4
Use
to select
USB
, then press
OK
.
5
Use
to select the desired update file, then press
OK
.
6
Use
to select
Yes
, then press
OK
.
•
Read the on-screen instructions and confirm that you want to
continue with the installation.
Do not remove the USB storage device or turn the TV off
while upgrade is in progress.
Software update is in progress. Please wait.
7
When the software upgrade is completed, press
to set the unit into
standby mode, then remove the USB memory stick.
8
Unplug the AC power cord for a few seconds from AC outlet and plug
it again.
9
Press
again to turn the unit on.
•
The TV starts up with the new software.
•
For further assistance, please contact call center.
45
.
English
Continued on next page.
65PFL6601 serial numbers beginning with DS4A1703 or higher numbers / 75PFL6601 serial numbers beginning with GZ2