Installing the stands
(65PFL5602)
1
Remove the tape on the bottom of the TV set and the plastic bag.
2
Fasten the matching stand to the TV with 2 screws (included). While
fastening the screws, hold the stand to prevent it from falling. Also,
make sure to attach the stand parallel to the bottom of the TV set, as
shown in the enlarged illustration.
2 screws
required
3
Fasten the other stand to the TV with 2 screws (included). While
fastening the screws, hold the stand to prevent it from falling.
2 screws
required
4
Both stands should now be securely fastened.
Note(s)
•
A wide open space is recommended for assembly.
•
A Phillips-head screwdriver is required to fasten the stands to the TV set.
•
When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly
attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.
•
To remove the stand from this unit, unscrew the Phillips-head screws by reversing the
procedure. Be careful not to drop the stand when you remove it.
Lifting the TV set
Carefully lift the TV set as shown in the illustration and place it onto a
stable, level surface.
Removing cardboard
Remove the cardboard attached to the screen. You are now ready to set
up and enjoy your Philips TV.
Installing the remote control batteries
1
Slide the battery cover off the back of the remote control.
2
Insert the two included batteries (AAA, 1.5V). Be sure the + and – ends
of the batteries line up with the markings inside the case.
3
Slide the cover back into position.
Note(s)
•
Remove the batteries if not using the remote control for an extended period of time.
11
.
English
Continued on next page.
65PFL6601 serial numbers beginning with DS4A1703 or higher numbers / 75PFL6601 serial numbers beginning with GZ2
