the microphone on the front side of the remote
control starts blinking.
2 -
The remote control must be kept close to the TV
(within 1m distance) during pairing in order to ensure
success.
3 -
If the TV does not launch the voice control
field when press
, pairing was unsuccessful.
4 -
It is advisable to wait until the set has fully started
up and launched all background processes before
pairing mode is entered as the toast message
containing further instructions may appear too late,
thereby negatively impacting the pairing procedure.
Pairing or pairing again
If the pairing with the remote control was lost, you
can pair the TV with the remote control again.
You can simply long press
the
PAIR ( SOURCES)
key (approximate for 3
seconds) for pairing.
Alternatively, go
Settings
>
Wireless and networks
>
Remote control
>
Pair remote control
, then follow
the on-screen instructions.
A message appears when the pairing is successful.
Remote Control Software
Settings
>
Wireless and networks
>
Remote
control
>
Remote control info
Once the remote control is paired, you can check the
current remote control software version.
Settings
>
Wireless and networks
>
Remote
control
>
Update remote control software
Check available remote control software for updates.
4.3
Voice Search
You can search for videos, music or anything else on
the Internet by simply using your voice. You can
speak into the microphone on the remote control.
You need to pair the remote control to the TV before
use voice search.
To use Voice...
1 -
Press
on remote control, the blue light on the
remote control lights up and the search field
opens, the microphone is active.
2 -
Speak out what you are looking for with clear
pronunciation. You can speak for 10 seconds before
the microphone switches off. It might take some time
for the results to appear.
3 -
In the list of search results, you can select the
item you want.
4.4
IR Sensor
The TV can receive commands from a remote control
that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point
the remote control at the infrared sensor on the front
of the TV.
Warning
Do not put any objects in front of IR sensor of the TV,
it may block the IR signal.
4.5
Batteries
If the TV does not react on a key press on the remote
control, the batteries might be empty.
To replace the batteries, open the battery
compartment on the back-bottom of the remote
control.
1 -
Slide the battery door in the direction shown by
the arrow.
2 -
Replace the old batteries with 2 Alkaline, type
AAA-LR03-1.5V
batteries. Make sure the
and the
ends of the batteries line up correctly.
3 -
Reposition the battery door and slide it back until
it clicks.
Remove the batteries if you are not using the remote
control for a long time.
Safely dispose of your old batteries according to the
end of use directions.
For more information, in
Help
, select
Keywords
and
look up
End of use
.
4.6
Cleaning
Your remote control is treated with a scratch-resistant
coating.
To clean the remote control, use a soft damp cloth.
Never use substances such as alcohol, chemicals or
12
