1 -
Hold your remote control at the listening position
and point it towards the TV during the tuning process.
2 -
Select
Calibrate now
or
Calibrate again
to start
the calibration.
3 -
A test sound will be played and measured
through your remote control. Hold your remote
control and point it towards the TV, this can take
several seconds.
4 -
Once your TV speakers are successfully
calibrated, select
Test
to listen to the sound before
and after the TV speakers are calibrated. Select
Apply
to accept the setting or select
Try again
to redo the
calibration.
5 -
When room calibration setup is successful and
applied, TV shall return to the Settings menu. Now go
to
Settings > Sound > Room calibration and
select
Apply calibration
to tune the audio output from
TV speakers.
Advanced Sound Settings
Volume Control
Auto volume
Settings > Sound > Advanced > Auto volume.
Select
On or Off
to switch on or off the auto volume
adjustment.
Select
Night Mode
for a more comfortable quiet
listening experience.
Delta volume
Settings > Sound > Advanced > Delta volume.
The Delta volume setting can be used to adjust to
balance the sound level difference between the TV
channel and the HDMI source input. Press the
arrows
(up) or
(down) to adjust the delta
value for TV speaker volume.
* Note: Delta volume is available when the input
source is set to HDMI or Analogue sources and the
Audio out is set to
TV speakers
or
HDMI sound
system
.
Audio Out Settings
Audio out
Settings > Sound > Advanced > Audio out.
Set the TV to play the sound on TV or on the
connected audio system.
You can select where you want to hear the TV sound
and how you want to control it.
• If you select
TV speakers off
, you permanently
switch off the TV speakers.
• If you select
TV speakers
, the TV speakers are
always on.
With an audio device connected with HDMI CEC,
select
HDMI sound system
. The TV will switch off
the TV speakers when the device is playing the
sound.
If there is a Bluetooth speaker already paired with
your TV, it will be available on the audio out device
list with its device name.
eARC
Settings > Sound > Advanced > eARC.
Set eARC mode to
Automatic
or
Off
.
Digital Output Settings
Digital output settings are available for optical and
HDMI ARC sound signals.
Digital out format
Settings > Sound > Advanced > Digital out
format.
Set the audio out signal of the TV to fit the sound
capabilities of the connected Home Theatre System.
•
Stereo (uncompressed)
: If your audio playback
devices have no multichannel sound processing,
select to only output stereo content to your audio
playback devices.
•
Multichannel
: Select to output multichannel audio
content (compressed multichannel sound signal) or
stereo audio content to your audio playback devices.
•
Multichannel (bypass
): Select to output Dolby
Digital Plus or DTS content to your audio playback
devices or Home theatre system.
- Make sure your audio playback devices support
Dolby Atmos feature.
- SPDIF output (DIGITAL AUDIO OUT) will be
disabled when streaming Dolby Digital Plus content.
Digital out levelling
Settings > Sound > Advanced > Digital out
levelling.
Adjust the loudness level from device which is
connected to digital audio output (SPDIF) or HDMI.
• Select More to have louder volume.
• Select Less to have softer volume.
Digital out delay
Settings > Sound > Advanced > Digital out
delay.
50
