English
33
8239 300 32892
Troubleshooting
Problem
Solution
–
Insert a readable disc with the playback side
facing down. The DVD+R/CD-R must be
finalised.
–
Check the disc type, colour system and region
code.
–
Check for any scratches or smudges on the disc.
–
Press SYSTEM SETUP
to turn off the setup
menu screen.
–
You may need to enter the password in order
to change the parental control rating level or
to unlock the disc for playback.
–
Moisture has condensed inside the system.
Remove the disc and leave the system turned
on for about an hour.
–
The features may not be available on the DVD.
–
Changing the language for the sound or subtitle
is prohibited on the DVD.
–
Press CENTER
+-
or REAR
+-
to adjust
the volume level.
–
Make sure the centre and rear speakers are
connected correctly.
–
Press SURROUND button to select a correct
surround sound setting.
–
Make sure the source you are playing is
recorded or broadcast in surround sound
(DPL II, Dolby Digital, etc.)
–
If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
–
Increase the distance between the system and
your TV or VCR.
–
Tune in to the correct frequency.
–
Place the antenna farther away from any
equipment that may be causing the noise.
–
Select the source (DISC or TUNER, for
example) before pressing the function button
(
ÉÅ
,
S
,
T
).
–
Reduce the distance between the remote
control and the system.
–
Replace the batteries with new ones.
–
Point the remote control directly toward the
IR sensor.
–
Check that the batteries are loaded correctly.
–
Press DIM again.
–
Place the DVD system as far away as possible
from electrical devices that may be causing
interference.
The DVD player does not start playback.
Cannot activate some features, such as
Angles, Subtitles, or multi-language
Audio.
There is no sound from the centre and
rear speakers.
Radio reception is poor.
The remote control does not function
properly.
The display panel is dark.
Low hum or buzz sound.
001-035-MX2500D-78-Eng2
7/20/04, 3:12 PM
33
