Select a surround effect from the preset types.
• Upmix - Upmix to take full advantage of all
speakers.
• Standard - Speakers output follow the original
channels.
• Voice - Enhanced the dialog in the vocals.
• Surround AI - Optimum surround effect using AI
analysis.
DRC
Settings > Sound > EasyLink 2.0 > DRC.
Select the preferred Dynamic Range Control (DRC).
• Auto - Dynamic range is automatically adjusted.
• On - Optimize the dynamic range.
• Off - Turn off dynamic range adjustment.
Height speakers
Settings > Sound > EasyLink 2.0 > Height
speakers.
Select the preferred height speakers movement. The
setting is only available when connected device is
compatible with TV for the feature.
• Auto - Dynamic movement follow contents.
• On - Always elevated.
• Off - Flat position.
Select sound stage
Settings > Sound > EasyLink 2.0 > Sound stage.
Select a listening experience. The setting is only
available when connected device is compatible with
TV for the feature.
• Auto - Dynamic setting follow contents.
• On - Immersive Sound Stage, good for watching
movies.
• Off - Crystal Sound Stage, good for listening to
music and dialogue.
Reset all to default
Settings > Sound > EasyLink 2.0 > Reset all to
default.
Reset all the EasyLink 2.0 sound settings back to the
original factory settings.
Room Calibration
Room calibration
Settings > Sound > Room calibration.
This calibration will allow the TV to determine the
acoustics in your room and provide optimized sound
quality on the TV speakers that best match the
acoustics.
You need to pair your remote control with the TV
before starting the setup and make sure the TV
Audio
out
setting is
TV speakers
. For a more accurate result,
please keep the room quiet.
To start the room calibration…
1 -
Hold your remote control at the listening position
and point it towards the TV during the tuning process.
2 -
Select
Calibrate now
or
Calibrate again
to start
the calibration.
3 -
A test sound will be played and measured
through your remote control. Hold your remote
control and point it towards the TV, this can take
several seconds.
4 -
Once your TV speakers are successfully
calibrated, select
Test
to listen to the sound before
and after the TV speakers are calibrated. Select
Apply
to accept the setting or select
Try again
to redo the
calibration.
5 -
When room calibration setup is successful and
applied, TV shall return to the Settings menu. Now go
to
Settings > Sound > Room calibration and
select
Apply calibration
to tune the audio output from
TV speakers.
Advanced Sound Settings
Volume Control
Auto volume
Settings > Sound > Advanced > Auto volume.
Select
On or Off
to switch on or off the auto volume
adjustment.
Select
Night Mode
for a more comfortable quiet
listening experience.
Delta volume
Settings > Sound > Advanced > Delta volume.
The Delta volume setting can be used to adjust to
balance the sound level difference between the TV
channel and the HDMI source input. Press the
arrows
(up) or
(down) to adjust the delta
value for TV speaker volume.
* Note: Delta volume is available when the input
source is set to HDMI or Analogue sources and the
48
