PhotoFrame Firmware Upgrade Instructions
Applicable models
8FF3FPB, 8FF3FPW
Firmware version
058
Release date
October 20, 2008
Release notes
- Preloaded baby photo is deletable
!
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1
Format SD (Secure Digital) card
2
Copy all files from the ‘
Firmware
’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example
F:\
)
3
Make sure PhotoFrame is powered Off
4
Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5
Push the Power button to power on the PhotoFrame
6
The firmware upgrade will start automatically
!
Warning:
Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
!
7
When "
Please reboot system!
" shows, firmware upgrade has finished
8
Remove the memory from the PhotoFrame
9
Power Off the PhotoFrame and Power On afterwards by pushing the Power button
10
The upgrade has completed
You can check the new firmware version via
Setup
→
Status
→
Firmware
.
