Philips ADD4965, User Manual

If you first turn on the switch, for optimal temperature, the dispenser will need around 20
minutes for hot water and around an hour for cold water.

4

Instruction

(1) 

Unpacking the water dispenser

  · Cut and remove the straps from the box. DO NOT turn the box upside down, or lay it on its
    side. The bottom of the box is separate from the top section. Lift straight up on the top box
    section to remove the top box section. Remove the Styrofoam packaging and plastic bag. 
    Lift the water dispenser off the bottom of the bottom of the box. Wipe it clean if necessary.
  · Place the machine on a hard, flat surface. Make certain the unit is leveled. The unit should
    not be placed near direct sunlight or other source of heat.
  · It is best to place the water dispenser in an area with good air circulation. Make sure there is
    at least 4 inches (10cm) of space between the back of your water dispenser and the wall. 
    Keep a minimum distance of 2 inches (5cm) on each side of your water dispenser.

  Warning: 

the drain plug on the back of the unit may become loose during shipping. Fasten

  the drain plug tightly before you start to operate the unit. If the drain plug is loose, the unit
  may leak and cause floor damage.

(2) 

Settling water bottle

  · Make sure the water dispenser is not plugged into an electrical outlet.
  · Open the door of the lower cabinet.
  · Place full water bottle on floor. Remove the plastic cover over the mouth of the water bottle.
  · Place the stainless tube inside the bottle and place the water bottle cap firmly over the
    mouth of the water bottle.
  · Attach the hose to the top of the cap using the quick connect system shown below*.
  · Slide the bottle inside the cabinet and close the lower cabinet door.

  * Your new water dispenser features an adjustable quick connect system. For proper
    operation, make sure the connector is sealed tight (Fig. 1);
    The connector can be removed easily for cleaning with warm soapy water (Fig. 2);
    The stainless steel tube can be adjusted up and down to accommodate both 3 gallon and 5
    gallon water bottle (Fig. 3).

4