English
Congratulations on your purchase and welcome to
Philips!
To fully benefit from the support that Philips offers,
register your product at www.philips.com/welcome.
Controls (see
1
)
1
TUNING
– in FM/FMST/MW mode, fine tunes a station.
2
;
– 3.5 mm stereo headphone socket.
3
VOL
F
– adjusts the sound level.
4
Band selector
– selects the waveband:
FM, FMST, or MW
.
5
ON/OFF
– switches on or off the set
6
Battery compartments
POWER SUPPLY
Batteries (not included)
Open the battery door and insert one alkaline battery, type AAA, R03 or
UM4, as indicated in the battery compartment.
• Incorrect use of batteries can cause electrolyte leakage and will corrode
the compartment or cause the batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon zinc. Only use batter-
ies of the same type for the set.
• When inserting new batteries, do not try to mix old batteries with the
new ones.
• Remove the batteries if the set is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed of
properly.
Batteries contain chemical substances, so they should be disposed
of properly.
This set complies with the radio interference requirements of the
European Union.
General information
Antennas
• For MW, the set uses a built-in antenna. Direct this antenna for best
reception by turning the whole set.
Connecting headphones
• You can connect headphones to the headphone socket.
RADIO RECEPTION
1
Push the
OFF/ON
control to
ON
to switch on the set.
2
Set the band selector to
FM
,
FMST
, or
MW
.
3
Select your station using the
TUNING
control.
4
Adjust the sound with the
VOL
F
control.
5
Push the
OFF/ON
control to
OFF
to switch off the set.
SAFETY & MAINTENANCE
• Do not expose the set, batteries to humidity, rain, sand or excessive
heat caused by heating equipment or direct sunlight.
• The apparatus shall not be exposed to dripping or splashing.
• Do not cover the ventilation openings with items such as newspapers,
table-cloths, curtains, etc.
• No objects filled with liquids, such as vases, shall be placed on the appa-
ratus.
• No naked flame sources, such as lighted candles, should be placed on
the apparatus.
• The mechanical parts of the set contain selflubricating bearings and
must not be oiled or lubricated.
• To clean the set, use a dry cloth. Do not use any cleaning agents con-
taining alcohol, ammonia, benzene or abrasives as these may harm the
housing.
• Excessive sound pressure from earphones and headphones can cause
hearing loss.
• Battery shall not be exposed to excessive heat such as sunshine, fire or
the like.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set
for repair.
If you are unable to remedy a problem by following these hints, consult
your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under
no circumstances should you try to repair the set yourself, as this will invalidate
the guarantee.
Problem
– Possible cause
• Remedy
No sound /power
– Volume not adjusted
• Adjust the
VOL
.
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Poor radio reception
– Weak radio signal
• For MW, the set uses a built-in antenna. Direct this antenna for best
reception by turning the whole set.
