14
English
Pumping instructions
Warning: Before you remove the pump body from your breast, always switch off the breast pump to
release the vacuum.
Warning: Do not continue pumping for more than 5 minutes at a time if you do not succeed in
expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the pump and consult
your healthcare professional.
Note: If you regularly express more than 125 ml/4 fl oz per session, you can purchase and use a 260 ml/9 fl oz Philips
Avent Natural bottle to prevent overfilling and spillage.
1. Wash your hands
thoroughly with soap and
water and make sure that
your breast is clean.
2. Place the breast pump kit
onto your breast. Make sure
that you center your nipple.
3. Press and hold the on/
off button until the device
switches on. The indicator
lights go on to indicate that
the device is in stimulation
mode.
4. The breast pump starts
in stimulation mode and
slowly increases its vacuum
to the last used stimulation
suction level (or level 5
when used for the first
time).
5. Use the 'level up' and
'level down' buttons to
change the suction level to
your preference.
6. After 90 seconds the
breast pump will switch
smoothly to expression
mode and slowly increase
its vacuum to the last used
expression suction level (or
level 11 when used for the
first time).
7. If your milk starts flowing
earlier or if you want to
switch from expression
to stimulation mode, you
can switch modes with the
mode selection button.
8. Briefly press the on/off
button if you want to pause.
To continue, briefly press
the on/off button again.
3 sec.
90 sec.
Summary of Contents for Avent SCF391
Page 2: ......
Page 3: ...1 C B A C B A A1 B1 B2 B3 B4 B5 A2 A3 C5 C3 C4 C2 C1 B6 A4 A5 ...
Page 4: ......
Page 69: ......
